Les plaques de transfert de chaleur Omega Slot sont un moyen efficace de distribuer la chaleur rayonnante des tubes PEX.
Les plaques de transfert de chaleur HWALU Omega offrent un moyen efficace de distribuer la chaleur rayonnante des tubes PEX.. Fabriqué en Chine à partir de tôle d'aluminium polie. Les canaux sont en forme d'oméga enveloppant (ω) qui s'ajustent parfaitement et maintiennent très efficacement le tuyau dans le système au-dessus du niveau du sol.
Plaque de transfert de chaleur Omega
HWALU Omega Heat Transfer Plates Single and Double Slot Heat Transfer Plates are designed for radiant floors installed under suspended wood floor structures. The boards are installed between 16″ wood joists or trusses. In the middle of the PEX pipe that has run 8″. In the middle. The boards should be installed 1″ apart. The gap between them.
HWALU Omega heat transfer panels can be used in new construction or retrofits where joist cavities are open for installation of radiant heating systems.
The system can be installed under the subfloor by first laying the pipe and temporarily securing it to the subfloor with Ross pipe fasteners. Lay the single slot plate over the pipe and fasten it to each side of the slot with a row (at least 4) of staples.
Double-slot panels are secured in a similar fashion.
D'abord, use a row of 4 staples parallel to one side of the groove. Then, snap the plate over the two tubes in the joist cavity. Enfin, place a second row of staples between the two grooves, followed by a third row of staples along the opposite edge of the heat transfer plate.
HWALU Omega Heat Transfer Plates can also be used to install 1″ PEX pipe on the subfloor or ceiling. The planks provide depth for the grooves in each plank. Le motif d'agrafage sera le même que celui utilisé sous le sous-plancher
